Welcome, Guest. Please login or register.
Did you miss your activation email?
September 24, 2017, 10:53:14 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Galil (Moderators: smurph, kcrouch)
| | |-+  No DRO readings with Mach 3 and GALIL DMC-1740
Pages: 1   Go Down
Print
Author Topic: No DRO readings with Mach 3 and GALIL DMC-1740  (Read 105 times)
0 Members and 1 Guest are viewing this topic.
ddelzel
Holding

Offline Offline

Posts: 2


View Profile
« on: September 12, 2017, 11:41:47 AM »

For approximately 15 years I used a program called WinGCNC with a Galil DMC-1740 controller. All was good.  Recently my computer crashed and I have been unable to locate my backup copy of the WinGCNC program.  I purchased Mach3 and the Galil plugin.  I can get the program to recognize the Galil card but I have no DRO readouts.  If I energize the servos, the table moves in a negative Y direction until it contacts the limit switch but still with out DRO readings.  This is on a Bridgeport Series I with 3 axis servo motors.  I have tried different config settings without success and am out of ideas.  Has anybody had a similar experience?
Logged
ddelzel
Holding

Offline Offline

Posts: 2


View Profile
« Reply #1 on: September 12, 2017, 03:53:33 PM »

Un-checking the motor option boxes Galil plugin configuration made the encoders read.  Now I need to figure out how to scale them so they are accurate.
Logged
Pages: 1   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!