Welcome, Guest. Please login or register.
Did you miss your activation email?
November 17, 2017, 02:26:38 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  dspMC/IP Motion Controller (Moderator: Vital System Support)
| | |-+  Hall Effect for Spindle Speed Feedback
Pages: 1   Go Down
Print
Author Topic: Hall Effect for Spindle Speed Feedback  (Read 433 times)
0 Members and 1 Guest are viewing this topic.
dunnitagain
Active Member

Offline Offline

Posts: 38


View Profile
« on: September 05, 2017, 05:46:21 PM »

    Can a Hall Effect be used as Spindle Speed Feedback ? I have a LARGE ! VMC that has high and low range speed through belts, but had a Hall sensor from the OEM .
For Spindle speed feed back. I have Mach4 , everthing works, but spindle has no reference to Mach4 for accurate RPM.
Logged
garyhlucas
Active Member

Offline Offline

Posts: 531


View Profile
« Reply #1 on: September 05, 2017, 08:12:06 PM »

Hall Effect is the method of detection. Typically those sensors have some standard transistor output sinking or sourcing. Industrial stuff usually works over a range of 10 to 30 vdc, while most hobby boards use  5 vdc so that may be an issue, or not.
Logged
dunnitagain
Active Member

Offline Offline

Posts: 38


View Profile
« Reply #2 on: September 06, 2017, 06:54:51 AM »

 Gary , this is an 93 model Fadal , it used 5v for the hall sensors . I'm just not sure how to hook it up to the board for feed back. Or  could I just put a prox in the halls
place and use the same magnet?
Logged
Pages: 1   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!