Hello Guest it is April 16, 2024, 05:13:31 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Support synchronous with motion commands M10Px/M11Px for Mach3  (Read 2804 times)

0 Members and 1 Guest are viewing this topic.

Offline shad71

*
  • 33 33
    • View Profile
    • NEURON Industrial Torch Height Control
Support synchronous with motion commands M10Px/M11Px for Mach3
« on: April 09, 2017, 05:18:26 AM »
Hello!
Does the HiCON INTEGRA controller support synchronous with motion commands M10P(output number)/M11P(output number) for Mach3 and M62 P(output number)/M63 P(output number) for Mach4?
Thank you!
Logged
--Andrew

Offline Vital System Support

*
  • 394 394
    • View Profile
Re: Support synchronous with motion commands M10Px/M11Px for Mach3
« Reply #1 on: April 09, 2017, 12:53:15 PM »
hi shad71,

HiCON Integra supports Mach4 sync outputs M62/M63.  Sorry no support for Mach3 M10/M11.

regards

Rufi
VitalSys
Logged

Offline shad71

*
  • 33 33
    • View Profile
    • NEURON Industrial Torch Height Control
Re: Support synchronous with motion commands M10Px/M11Px for Mach3
« Reply #2 on: April 09, 2017, 03:06:13 PM »
Thank you Rufi.
Logged
--Andrew
Pages: 1   Go Up
« previous next »