Hello Guest it is March 28, 2024, 10:31:06 PM

Author Topic: Move over to 57CNC instead of 57E?? Help  (Read 2093 times)

0 Members and 1 Guest are viewing this topic.

Move over to 57CNC instead of 57E?? Help
« on: February 20, 2017, 02:34:05 PM »
SO I'm having problems with my Pokeys 57E connected to CNC4PCs M16 breakout board. I don't like that the 57E is hooked up to a breakout board not made by pokeys. Arturo is great, but doesn't have all the answers and it's getting frustrating to try to figure everything out. SO I'm think I'd rather have a BOB made by pokeys. Well the 57CNC has all the options built in.

DO you think the 57CNC would be a great replacement for my other stuff?

I guess all I need is:

Motor Control
Spindle 10V output
Limit Switch
Threaded - So spindle encoder hookup

Offline dude1

*
  •  1,253 1,253
    • View Profile
Re: Move over to 57CNC instead of 57E?? Help
« Reply #1 on: February 20, 2017, 06:36:25 PM »
I have one it's plug in and almost go the only thing I had to set up was the pwm everything else does it by it's self
Re: Move over to 57CNC instead of 57E?? Help
« Reply #2 on: February 20, 2017, 06:55:53 PM »
Cool. Good to know. I just thing if I use one device instead of a device attached to another device it'll help solve stuff in the long run.