When the limit switches, being NC, are not triggered does the Pokeys 57E board have red LEDs by the limit RJ45 Port? I ask because when I had GND hooked up to the limit switches common wires the LEDs were barely lit up. I mean hard to even see. When I use 5V they light up bright. When I push on a limit switch to simulate a trigger the LED turns off.
I'm not sure if this is normal or not, but I'm also having another weird problem. The E-Stop button is NC, normally closed, but I have to have the checkmark box for 'invert estop' check marked to have it work. It's totally backwards. I wonder if there's something wrong with my board.