Hi
I own a AKZ250 USB Card, but I am in a little doubt about the output pins 0-7, I wont to use either pwm or on/off as outputs.
How do I wiring the pin.
I think it would be something like:
AKZ250 outputpin (0-7) num#3
connected to
AKZ250 5v pin with a 1k resistor
would this give me a 0v-5v output TLL from AKZ250 outputpin (0-7) num#3
I have been measuarred the voltage from AKZ250 outputpin (0-7) num#3 with ground to 0.6v inactive and floating voltage among 0-3.7v when active.
How to wiring a outputPin or the pwm pin?
/jokerper