Welcome, Guest. Please login or register.
Did you miss your activation email?
September 25, 2017, 08:29:14 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Mach3 and G-Rex
| | |-+  Installation of Mach3Version D1.90.038 not quite complete
Pages: 1   Go Down
Print
Author Topic: Installation of Mach3Version D1.90.038 not quite complete  (Read 3635 times)
0 Members and 1 Guest are viewing this topic.
cabtug
Active Member

Offline Offline

Posts: 5


View Profile
« on: December 02, 2016, 12:36:30 AM »

I have installed Mach3 vD1.90.038 on an HP m7330n running Windows 7 Pro 32-bit, but according to the instructions manual I noticed a couple of steps that was missing.

1. The Setup Finished window didn't have the "Load Mach3 Driver" checkbox, only "Install English Wizards" checkbox was listed.
2. After clicking [Finish] button for setup I did not get the popup message, "Master License File found and copied to Folder".
3. I did not get the popup message, "Mach3 driver is now installed. You should Re-Boot before running program again.

After rebooting PC and running progam (MACH 3 MILL), I get a popup message, "Error Starting after prep".  Moving the arrows on keyboard doesn't control X,Y,Z axis; data on Mach3 is changing though.  I've confirm setup of the pin in Mach 3.

Any help would be greatly appreciated!

Carl
Logged
cabtug
Active Member

Offline Offline

Posts: 5


View Profile
« Reply #1 on: February 28, 2017, 07:05:35 PM »

Resolved my issue; uninstalled version D1.90.038 and replaced it with 3.043.066!

works like a champ!
« Last Edit: February 28, 2017, 07:08:19 PM by cabtug » Logged
Pages: 1   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!