Hi Guys,

Hope somebody can help me with this. I searched the forum but didn't see any problem like mine...

I'm running demo mode of mach3. when i run it without the parallel driver installed mach3 works fine. g-code is loading and toolpath is generated perfectly. HOWEVER, as soon as i install the parallel driver and i load the same g-code the toolpath only shows a small section and when i scroll thru the g-code on program run page it seems to be "stuck" at random lines.

I assume this has nothing to do with it being demo version and more with a conflict? I have already tried another port address but this didnt help either....

anybody has an idea?. I ran out of ideas so any help is welcome!

cheers,

Mis.

No, it's a demo limitation, 500 lines of code is all it will display.

ah!!!...dumb me  ....I just purchased a license.

thanks.