Hi Ron,
I keep getting this issue. Most recently it happened about 30 minutes ago. I created a .job, saved the g-code, and ran the code. I needed to make a small adjustment to the operation, when I went to load it all I had was tool changes. I created this operation on the licensed software, saved it on there, and tried to reopen it there. It all happened within a span of maybe an hour. Frustrating to say the least. I've taken to sketching these operations on paper and writing down their details so that all isn't lost after I close the software.
I'm on 2.0.4x1, windows 7 x64.
Any ideas?