Welcome, Guest. Please login or register.
Did you miss your activation email?
December 12, 2017, 09:07:09 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  HiCON Motion Controller (Moderator: Vital System Support)
| | |-+  VFD Spindle with HiCON Integra 7766 and Mach4
Pages: 1   Go Down
Print
Author Topic: VFD Spindle with HiCON Integra 7766 and Mach4  (Read 7453 times)
Zaidron and 1 Guest are viewing this topic.
Mauri
Active Member

Offline Offline

Posts: 212


View Profile
« on: June 03, 2015, 03:58:28 PM »

Hi,
Is there anyone who has installed a Huanyang VFD 24k Spindle to J12 Socket of the HiCON Integra 7766 card?
Our Huanyang VFD has DCM, FOR, ACM and VI connections to make it work.
We only need FORrward motion on the spindle.
We where planning to connect as per below.
J12 on HiCON
GND = ACM
DAC = VI
RLC = DCM
RL1 = FOR
Is this correct?
Do I need to have 24V on the RL1 Relay?
What would be the settings required on Mach4 configuration to be able to use in the G Code S24000, M03 and M05 to control the spindle?
Also how do you implement a delay to ensure the spindle is at full speed before it starts cutting in Mach4?
Regards,
Mauri.

Logged
francocncprojects
Active Member

Offline Offline

Posts: 26


View Profile
« Reply #1 on: May 16, 2017, 10:14:19 PM »

Hi - I can't help you at the moment but I plan on interfacing a Huan Yang VFD to my Integra Hobby in the very near future.  I'll drop you a line once I get it working.
Logged
Mauri
Active Member

Offline Offline

Posts: 212


View Profile
« Reply #2 on: May 16, 2017, 10:30:57 PM »

Hi,
I had mine working back in July 2015.
Regards,
Mauri.
Logged
lsgreen
Active Member

Offline Offline

Posts: 3


View Profile
« Reply #3 on: November 23, 2017, 07:23:19 PM »

Hey Mauri, are the settings that are listed above the ones that ultimately worked for you? I am in the process of setting up the same VFD on a 7766 and was hoping to confirm these settings.
Thanks, Lou


Sent from my iPad using Tapatalk
Logged
Mauri
Active Member

Offline Offline

Posts: 212


View Profile
« Reply #4 on: November 25, 2017, 02:18:56 PM »

Isgreen,
The Doc below shows the Mach4 settings for the VFD and Spindle on HiCON card.
Regards,
Mauri.

* Spindle VFD Setup with HiCON and Mach4.doc (268 KB - downloaded 23 times.)
Logged
lsgreen
Active Member

Offline Offline

Posts: 3


View Profile
« Reply #5 on: November 25, 2017, 07:43:30 PM »

Thanks for the help. Works perfect.
Logged
Pages: 1   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!