Hello Guest it is April 23, 2024, 08:08:07 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Pokeys57E and ChargePump  (Read 3972 times)

0 Members and 1 Guest are viewing this topic.

Offline Weerasak

*
  • 44 44
    • View Profile
    • http://www.cncroom.com
Pokeys57E and ChargePump
« on: January 14, 2015, 07:54:01 PM »
Pokeys57E with firmware v3.1.45, does not stop generating charge pump signal when it lost connection. Can this be fixed in future version?

Thanks
Weerasak
Logged
The CNCRoom.com, the place where Industrial Hobbyists can talk and trade!
www.cncroom.com/forum

Offline NeoTO

*
  • 504 504
    • View Profile
    • PoLabs
Re: Pokeys57E and ChargePump
« Reply #1 on: January 15, 2015, 11:01:10 AM »
Enable the 'Pulse engine' option in Peripherals > Failsafe settings in PoKeys application set set the failsafe timeout.
Logged
www.poscope.com home of PoKeys USB HID, IO, USB, Ethernet controler and PoScope USB PC oscilloscope

Offline Weerasak

*
  • 44 44
    • View Profile
    • http://www.cncroom.com
Re: Pokeys57E and ChargePump
« Reply #2 on: January 16, 2015, 11:27:27 AM »
Thank you for pointing it out,

Please consider to put this option in Pulse engine tab in Mach3 plugin also. Configure all options from one place, make it easy to use.

Currently, I only use PoKeys application for setting IP address, upgrading firmware and clearing all setup.







Logged
The CNCRoom.com, the place where Industrial Hobbyists can talk and trade!
www.cncroom.com/forum
Pages: 1   Go Up
« previous next »