I thought this would be easy, but for the life of me I cant get Pokeys to illuminate a LED!
Led connected with 220 ohm Resistor pin 32 and ground. Polarity has been checked (and also reversed to verify)
Mach3 plugin: Pin 32 set to output, LED 804 (Start LED), Invert "Off" - Also tried lots of other LED numbers to see if I had the correct mapping
Pressing start and running some code the LED on the Pokeys does not illuminate, altho looking at it in low light, I can see a faint glow which is always on regardless of Mach 3 screen LED state, or Pokeys Settings.
Anyone have an idea why this would not be working?