Hi Ron and thanks for your prompt reply.
Am talking about installing the NFS Mill Wizard License File rather than operating the Mill Wizard software.
In the instructions for installing the License File one is requested to right click the icon.
I've pasted below a copy of Scott's instructions to refresh your memory
With regard to the INF file, you were correct here. It was my typo and should have read INI file.
The remainder of my comments still hold. And I am using Win XP
Scott's instructions.
1). Save it to some location on the PC that you registered (the Desktop is a
good choice)
2). Open the Mill Wizard (if using Win 7 or Win 8, right-click on
the shortcut icon and choose "Run As Administrator" from the menu)
3). Click on Help> About in the menu bar
4). Click the "Load License File" button on the About screen
5). Browse to the license file and Open it
6). Close and re-open the About screen to check that the license is
properly loaded - it should say "Licensed Copy" above the box with the PC
ID.
If you have any questions or problems that are not addressed by the
in-program Help, please post about them on the Newfangled Mill Wizard board
of the forums (
http://www.machsupport.com/forum/index.php/board,92.0.html).
This allows the entire community to contribute to - and benefit from - the
answers. Please search the forum first, to see if your particular issue has
been previously discussed, and feel free to post a new topic if it has not.