Hello,
I have a few jobs where I need to load a tool and then run a few short operations on multiple parts in my vice. I'd like to set up my code so that I load the tool in Mach3 once and then repeat the machining ops multiple times.
Would the following work? Would I just hit Stop after the last part?
-----------------------------
(program start)
M6 T1 (tool change)
G43 H1 (apply TLO)
M98 P1 L9999 (call subroutine)
M30 (end program)
O1
M0 (load part and hit cycle start)
(do some operations)
M99
----------------------------
Thanks,
Chris