Hello Guest it is March 29, 2024, 09:58:02 AM

Author Topic: G-Code Skips From Line 88 to M02 Then Back to Line 88  (Read 2999 times)

0 Members and 1 Guest are viewing this topic.

G-Code Skips From Line 88 to M02 Then Back to Line 88
« on: January 17, 2014, 09:38:22 PM »
Hi and thanks for reading this, I am new to Mach 3.

Title says it all.  I have 6 files of g-code and they all skip from line 88 to M02 (last line of all files) then back to line 88 and continue on normally.  I have reinstalled Mach 3 and that was no help.

All the lines in all the files all look the same so I don't know where to start.

Any ideas?

Mike
Re: G-Code Skips From Line 88 to M02 Then Back to Line 88
« Reply #1 on: January 17, 2014, 10:54:38 PM »
Here is one of the files.

Mike

Offline Graham Waterworth

*
  • *
  •  2,668 2,668
  • Yorkshire Dales, England
    • View Profile
Re: G-Code Skips From Line 88 to M02 Then Back to Line 88
« Reply #2 on: January 18, 2014, 03:23:47 AM »
It runs fine for me here.

Without engineers the world stops