Hello Guest it is March 28, 2024, 05:45:55 AM

Author Topic: Set up floating head in Mach3  (Read 5693 times)

0 Members and 1 Guest are viewing this topic.

Set up floating head in Mach3
« on: June 28, 2013, 02:55:10 PM »
Hi Everyone!

Extreme newbie.  My husband has put me on this project this summer and I really need some help. 

I am trying to set up the floating head switch in Mach 3.  These are the steps I am following:
Open Diagnostics screen
Move torch until it is just touching the metal then type zero in the Zpos position and hit enter
 
Here is where I run into problems.

When I move the torch up and down, the Digitize led won't light up on the Mach screen.

I'm at a loss.  Any help would be greatly appreciated.