I recently upgraded to a 23" monitor  and can not figure out how to get Mach 3 to fill the screen!! Any ideas I have tried everything I can think of I am running a plasma cutter only

Under General Config -> Screen Control tick the Auto Screen Enlarge option.

Dan

Under General Config -> Screen Control tick the Auto Screen Enlarge option.

Dan

Tried that

i found that if i go to machscreen and open the set file. resetting the res(Frame Size) to 1600x950.
the default screen fills my screen. may have to adjust to fit your screen

Quote from: Dan13 on March 05, 2013, 01:30:06 AM

Under General Config -> Screen Control tick the Auto Screen Enlarge option.

Dan

Tried that

You have tro close and restart Mach3 for it to take effect.

Yes. Either that or reloading the screen in Mach3.

Dan

I updated to the newest Mach3 version and the same happened. No full size on the screen.

In general config., do you have the high res screen tick box ticked?  Do other applications fill the screen?  Could it be your monitor needs adjusting?

Brett

Tanks, that worked!!