Welcome, Guest. Please login or register.
Did you miss your activation email?
July 25, 2014, 08:40:34 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  PoKeys (Moderator: NeoTO)
| | |-+  Mach 3 setup with Pulse engine
Pages: « 1 2   Go Down
Print
Author Topic: Mach 3 setup with Pulse engine  (Read 3042 times)
0 Members and 1 Guest are viewing this topic.
txpto
Active Member

Offline Offline

Posts: 28


View Profile
« Reply #10 on: April 26, 2012, 01:38:54 PM »

seldom I was in the same problem.
the solution was eliminate noise in VCC power supply of the motor controller.
USB connection between pc and pokeys fall when motor start chopper.
With and oscilloscope see signal vcc 5v and 24v of inverter... noise noise and more noise.

Separate via optocuplers step and dir and independent power supply and all ok.

Is my experience.

Enviado desde mi Transformer Prime TF201 usando Tapatalk 2
Logged
Pages: « 1 2   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!