This is my first post on this forum, but i think not the last!

Im trying to install the Mach3 plugin for pokeys on my computer with no C: -drive. The hard-drive on this computer has the letter K: .
When i try to run the installation program downloaded from Polabs page, it will stop and tell me to select another drive than C:, but there is no selection for that....

Please help me!

Thanks,

/Micke

Just either type K instead of C or browse to where you want it to go.
Hood

I cant find where to browse or type te location!

Assuming it is the same pokeys installer I have just looked at you do it from this part of the install. Either change the C to K or use the browse.
Hood

Wait a min, you said plugin, can you send a link to the one you are meaning?
Hood

it is the plugin for mach3 on pokeys homepage: http://www.poscope.com/pokeys56u
i dont get the screen above when i try to run that installer!

Please check these tread for the latest plugin: http://www.machsupport.com/forum/index.php/topic,21247.0.html
If you will still not be able to install it to K drive, please email us to: support (at) poscope.com

Thanks, now i have installed it soccesfully on my computer.

But now to the next problem...
I have installed the pluginin, and configured a few buttons on my pendant. The problem is that when i for example press the Z-- button, the machine will not stop jogging when i release the button! It is configured as Button 312. The problem is similar to other buttons too. When i test the inputs in PoKeys configuration program, the buttons works just fine.

Try inverting the input setting.
Hood

@msv: I will contact Brian in regards to these 'push to jog' buttons in Mach3. Apparently, these need special handling in the plugin.