Hi guys I'm getting a Run Error Line 2 unspecified failure.
It is stopping on the line for spindle start.
I can hit any key on the key board and it will start the program but the spindle
dose not start.
When the program starts running a VB scipt editor box appears,
The word DoSpinCW()
I have been generating code with the same cam software for about 5 years
and this is just started happening.
Here is a piece of the code
Thanks for any help
N1 G00 G43 G40.1 G17 G80 G50 G90
N2 G20
N3 (Deep Drill )
N4 M6 T1
N5 G43 H1
N6 M03 S1500
M8
N7 G00 Z0.50000
N8 X-0.30000 Y6.85000
N9 G83 X-0.30000 Y6.85000 Z-0.52197 R0.1 Q0.1 F5.0
N10G80
N11 G00 Z0.50000
N12 G83 X-1.90036 Y7.45000 Z-0.52197 R0.1 Q0.1 F5.0
N13G80
N14 G00 Z0.50000
N15 G83 X-4.10000 Y6.85000 Z-0.52197 R0.1 Q0.1 F5.0
N16G80
N17 G00 Z0.50000
N18 G83 X-6.30000 Y7.45000 Z-0.52197 R0.1 Q0.1 F5.0
N19G80
N20 G00 Z0.50000
N21 G83 X-9.00030 Y6.67013 Z-0.52197 R0.1 Q0.1 F5.0
N22G80
N23 G00 Z0.50000
N24 G83 X-10.69964 Y7.45000 Z-0.52197 R0.1 Q0.1 F5.0
N25G80
N26 G00 Z0.50000
N27 G83 X-12.90000 Y6.85000 Z-0.52197 R0.1 Q0.1 F5.0
N28G80
N29 G00 Z0.50000
N30 G83 X-15.09928 Y7.45000 Z-0.52197 R0.1 Q0.1 F5.0
M9
N31G80
N32 G00 Z5.0