After trying to keep the MHP mill up and running, I have finally given up. May the MHP RIP!
Now time for the UPGRADE.
I have started to strip all the electronics out of the cabinets, and disassemble most of the mill. Once it is disassembled, then I am going to repaint most of it.
This is what I am planning (unless something changes)
3 granite devices servo drives
1 DSPMC motion controller
2 I/O cards from Vital Systems
1 10 HP spindle with Toshiba VFD
While removing the existing components, I found some electronics that I am unsure what they are or what they are for. I will post some pictures later today.
I will keep everyone posted on the progress
Steve