Welcome, Guest. Please login or register.
Did you miss your activation email?
October 31, 2014, 08:46:08 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Third party software and hardware support forums.
| | |-+  M5 and M3 command getting lazy
Pages: 1   Go Down
Print
Author Topic: M5 and M3 command getting lazy  (Read 676 times)
0 Members and 1 Guest are viewing this topic.
Themadcow
Holding

Offline Offline

Posts: 1


View Profile
« on: December 15, 2011, 01:02:34 PM »

I have a plasma table setup with a gekodrive and an automotive relay attached to the plasma cutter, however when I run a program sometimes the m3 commands are not caught and the plasma is left turned on during a rapid move causing a gouge or a cut right through the part. I was wondering if this might be caused by mach3 or the relay? my f5 command doesn't work anymore either.

Do you need my mach3 xml sheet?
Logged
Pages: 1   Go Up
Print
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!