Chiming in on this topic.
Tool table works fine when I go into wizards and select one of the New Fangled Wizards , but if I go into Wizards and select something outside of New Fangled - say - Circular Pocket by Brian Barker -
when I put in a new tool number, the tool diameter does not change in the wizard window. When I post the code, the code does reflect the tool number I selected, but it refers to the wrong diameter in the code window (it shows whatever was in the wizard window previously). When the code runs the tool number and the tool diameter changes in the Tool Information window. Not a major problem, but it is disconcerting when reviewing the written code.
Bob @ BobsShop