Hello Guest it is April 25, 2024, 01:01:23 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Border properties  (Read 4613 times)

0 Members and 1 Guest are viewing this topic.

Offline krsykes23

*
  • 83 83
    • View Profile
Border properties
« on: July 27, 2011, 08:57:28 AM »
As a relative newcomer to Mach3, I was wondering if the raised border around the G-Code window and Toolpath, and the
inset border around the DRO's could be removed.  In other words, I require just a plain border (or preferably, no boarder at all)
Is this possible?
Logged

Offline Klaus1311

*
  • 531 531
    • View Profile
    • Hard - and Software
Re: Border properties
« Reply #1 on: July 27, 2011, 04:24:20 PM »
Hi


try to uncheck "Boxed DRO's and Graphics" in Config -> General Config.. in Mach3.
Don't forget to reload the set-file after changing the checkbox


Klaus
« Last Edit: July 27, 2011, 04:26:10 PM by Klaus1311 »
Logged
The brain isn't a soap, it doesn't shrink when used.

Offline krsykes23

*
  • 83 83
    • View Profile
Re: Border properties
« Reply #2 on: July 27, 2011, 04:49:55 PM »
Thanks Klaus.  Perfect!

Keith
Logged
Pages: 1   Go Up
« previous next »