Hello Guest it is March 28, 2024, 04:23:22 PM

Author Topic: Mach3 not performing M03 function  (Read 2982 times)

0 Members and 1 Guest are viewing this topic.

Mach3 not performing M03 function
« on: May 02, 2011, 02:50:29 AM »
Running a Plasma using M03 to O/P1 to control Hypertherm45 to initiate arc, can manually strike arc by toggling spindle on/off control or F5 but on running Gcode and even single stepping code, at M03 op nothing happens machine will perform as if it was cutting  any suggestions welcome

Offline BR549

*
  •  6,965 6,965
    • View Profile
Re: Mach3 not performing M03 function
« Reply #1 on: May 02, 2011, 10:38:31 AM »
Double check your M3 macro to make SURE the start code is there  DoSpinCW()

Just a thought, (;-) TP