Just purchased the Newfangled wizard and in general I'm pleased with it..
One thing that's been a bit of a nuissance, though, is the rectangle cutout wizard.
After crashing my Mach 3 several times while I waited for it to finish (after pressing make code), I realized that if I hit cancel and exit, I would get back to the Mach 3 screen and whatever code it had managed to finish would be posted..
The problem was that the wizard was starting at the correct Z and then going UP, so it never reached the correct depth (obviously) and wrote code that ran pass after pass raising the Z ad infinitum. (this happened no matter what combination of negative signs I tried out in front of both the step depth and final depth numbers)
After some debugging, I found that the problem went away if the step depth was *less* than the final depth, but if it was the same or more, then endless loop ensued.
What am I doing wrong?
Thanks!
-Chris