Hello Guest it is March 28, 2024, 03:08:17 PM

Author Topic: Need help with settings  (Read 4588 times)

0 Members and 1 Guest are viewing this topic.

Need help with settings
« on: October 30, 2010, 11:09:49 PM »
I have just changed computers and installed my old hard drive and hardware and now my software does not communicate with my machine.  I do not mind spending money to get it fixed can some one email me as to what time we can get together to see what my problem is.  thanks I am in central time zone in the USA.  sunday is OK as I need to have this up and running for Monday Morning.
you can email me or call me at 337-303-6146 just give me a few hours notice.
thanks

butch

Offline GeorgeRace

*
  •  53 53
  • My Home Built Airplane
    • View Profile
    • Race Consulting
Re: Need help with settings
« Reply #1 on: October 31, 2010, 08:21:54 AM »
Just a quick thought, as I recently did exactly the same thing.

I simply ran the Mach3 "Port Install" software routine again with my new machine and everything went right back to working properly.

How to do it is in our Mach3 install instruction information.

Hope this helps,

George
Check out my home page
http://www.mrrace.com