Hello Guest it is March 29, 2024, 07:40:39 AM

Author Topic: Reset Button on Mach3 demo software  (Read 6581 times)

0 Members and 1 Guest are viewing this topic.

Reset Button on Mach3 demo software
« on: July 13, 2010, 11:20:50 AM »
     Can I run the mach3 mill demo without having any electronics hooked up on my computer. I simply want to run a gcode demonstration on the software i downloaded. The reset button will not allow me to turn it off to proceed.

Offline ger21

*
  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: Reset Button on Mach3 demo software
« Reply #1 on: July 13, 2010, 11:39:16 AM »
In ports and pins, toggle the active low setting of the Estop pin.

Inputs, I think.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline RICH

*
  • *
  •  7,427 7,427
    • View Profile
Re: Reset Button on Mach3 demo software
« Reply #2 on: July 13, 2010, 12:00:53 PM »
If that dosn't work just assign an unused pin number, enable estop, and check Emulated
in CONFIG>PORTS & PINS>INPUT SIGNALS

RICH
Re: Reset Button on Mach3 demo software
« Reply #3 on: September 01, 2016, 03:14:29 PM »
Any  G code to simulate   E- stop  end of the program?   thanks.