Hello Guest it is March 28, 2024, 07:16:43 AM

Author Topic: minimum diameter?  (Read 4028 times)

0 Members and 1 Guest are viewing this topic.

minimum diameter?
« on: April 06, 2010, 11:10:58 AM »
Me again...sometimes when I import a DXF r12 I get to change the rulers to the correct diameter of stock but my profile diameter is way too big and it has a minimum that is larger than my set stock diameter?

I have been all thru the manual but still cant figure it out?

Offline RICH

*
  • *
  •  7,427 7,427
    • View Profile
Re: minimum diameter?
« Reply #1 on: April 06, 2010, 09:47:42 PM »
What LR imports is what you have drawn. If you drawing represents a diameter then in the OPtions menu  ( section 5.3 ) you should select diameter mode. Same goes for imperial or metric mode. You can change the stock diameter if you wish with the the penatgons  ( see section 6.2.1)
RICH