Hi
I'm having trouble getting the plugin to work with my VFD.
The PD settings in VFD is :
PD001=2
PD002=2
PD163=1
PD164=1
PD165=3
I can start and stop the spindle and it's operation is fine when in manual control (PD001=0, PD002=0)
However when i switch the PD001 & PD002 to 2 i cannot start the spindle from the mach3, i always get the message "E-Stop button pressed- Emergency mode active".
In the plugins menu i entered : Com port 5 as this is my HXSP-2108G converter port from device manager, then i entered baud rate 9600
VFD address 1 i checked spindle Amps & speed DRO's but i always get a value of 99 in PD001 & 2.
Here's also my monitoring session to com port 5 using the Serial Port Monitor program, i changed it to .txt format but it's original extension is .spm
Any suggestions welcomed
Thanks
Sergio