Hello Guest it is March 18, 2024, 11:35:03 PM

Author Topic: Mach3 + Galil  (Read 131639 times)

0 Members and 1 Guest are viewing this topic.

Hood

*
Re: Mach3 + Galil
« Reply #10 on: November 10, 2006, 04:22:23 PM »
Brian will this toolchanger plugin only be applicable to galil? If not it sounds perfect for my lathe retro.
Hood
Re: Mach3 + Galil
« Reply #11 on: November 10, 2006, 05:35:22 PM »
What I am thinking about doing will work for any Card that you have (even the Printer port)

Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Hood

*
Re: Mach3 + Galil
« Reply #12 on: November 10, 2006, 05:43:29 PM »
Excellent :)

Hood
Re: Mach3 + Galil
« Reply #13 on: November 12, 2006, 02:34:38 PM »
Brian,

Did you get a chance to send the video, to get it up on the site?
Re: Mach3 + Galil
« Reply #14 on: November 12, 2006, 07:16:29 PM »
The video is a bit big at 12 MB but I think I am going to put it on the FTP server.. shoudl be up in a few
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline chad

*
  • *
  •  361 361
  • When the going gets weird, the weird turn pro.
    • View Profile
Re: Mach3 + Galil
« Reply #15 on: November 13, 2006, 03:30:51 AM »
Boy Brian, that thing is a monster. Is that your shop?

ChAD

Re: Mach3 + Galil
« Reply #16 on: November 13, 2006, 07:42:10 AM »
It is at that shop that I have been running for the University of Maine :) I am getting done there but wanted to have that all up and running for them before I headed out the door...
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Mach3 + Galil
« Reply #17 on: November 14, 2006, 08:49:16 PM »
My Bridgeport BTC will like a Galil moving it around:)

Nice work Brian!!!!!!



Here is a project that I finished recently:
http://www.cnczone.com/forums/showthread.php?t=27147
« Last Edit: November 14, 2006, 08:51:07 PM by DennisCNC »
Re: Mach3 + Galil
« Reply #18 on: November 21, 2006, 12:45:57 PM »
Any news  about Mach + Galil econo series DMC (eg: DMC1842). Its look like the same as DMC1880 (programing, commands etc)? But cheaper.
Re: Mach3 + Galil
« Reply #19 on: November 26, 2006, 11:44:41 AM »
Should work... :)
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com