Machsupport Forum
Mach Discussion => Mach3 under Vista => Topic started by: sfleck on October 09, 2018, 09:40:40 AM
-
Mach3 is freezing up in the middle of a program. What is the best way to get it to restart from the point it left off at after restarting?
We tried entering the line it left off on, but that does not seem to work and it keeps defaulting back to 0.
-
The best thing to do is figure out why Mach3 is freezing, and fix it. I've never seen Mach3 freeze or lock up in over 10 years, and wouldn't use it if it did.
If your can live with it, try using Run From Here to resume.