Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: jganley on April 16, 2018, 10:28:29 AM

Title: UC100 problem
Post by: jganley on April 16, 2018, 10:28:29 AM
I am using a HobbyCNC EZBoard with the UC100 and Mach3 Software, I cannot get the Y Axis to work I have swapped motors around and they (motors) are good. When I turn on the controller all motors lock (for better word) including the Y Axis the UC100 has a steady green and blue light has anybody had troubles with the UC100?