Machsupport Forum

Third party software and hardware support forums. => dspMC/IP Motion Controller => Topic started by: peterc on June 30, 2017, 01:28:01 AM

Title: Backlash Settings
Post by: peterc on June 30, 2017, 01:28:01 AM

I am trying to use the backlash settings on my system: Mach3, Stepper motors with encoders on motors. 
Read through the manual and have tried different settings but don't change the back lash.  I do notice every time I hit the reset button after a E-stop the motor moves about 0.015mm which is less than the back lash setting entered.
  Has anyone got the back lash to work?  I am thinking it is for servo motors only.