Machsupport Forum
Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: ACP on February 04, 2017, 09:37:23 PM
-
Hello, sitting here trying to catch up on jobs after upgrading to mach4 and a 7762 vital card. Manage to license mach4 ok but i just cant seem to license mill wizard. Done step by step as directed.
-pc id copied from mill wizard (screwed that up the first time by getting it from mach4 as you can see my license history)
-opened email unzippied files
-copied .txt file to desktop
-ran wizard as admin (tried without as well)
-open license file in "about" sub-menu
-close license box
-reopen license box
-still demo
tried reinstall no change . This should not be this difficult. lol.
Pulling my hair out...
Any help would be great.
Thanks,
Mick
-
Did you open Mill wizard, go to help, about, load license file and then follow thos directions????????
Mike
-
Hi Mike,
Yes I did. Went to Help, About, open licenese file, Clicked file on desktop. Closed window, reopened window and nothing.
I licensed mach4 two days prior, Its more or less the same procedure is it not?
-
Sounds like you need to get a hold of tech support.