Machsupport Forum
Tangent Corner => Bargain Basement => Topic started by: dbcoop11 on October 01, 2015, 05:50:01 PM
-
I need room and I have a converted from a PC board drilling machine base to cnc mill that has X/Y hooked to DC Servo Gecko Drives running Yaskawa Motors. (Toroidal transformer with large Caps)Very large ball screws 30mm dia. plus. I hung a piece of cold rolled plate off of the gantry and have a Z axis,minus the motor the Z axis does have a holder for an 80mm dia spindle.I have the spindle for a hundred, but not the VFD for it any longer. It was running when I took it out of service. I toyed with sprucing it up,or stripping it , but thought if anyone from the area wanted it (McHenry County), they could have it. The table measures 39.39" X 27" and although it is on wheels, it is quite heavy,I'm guessing a little over a thousand pounds, so it would take a heavy duty trailer to pick it up. I have some pics if you give me an e-mail to send to.
Dave Cooper
-
Did u give this away already?
Pictures?
-
I still have it minus the z-axis, I may have enough pieces around to cobble one together though. The spindle is still available. I'll try to get some pics this weekend.
Coop
-
It's free right?
-
Yes, it is on wheels but quite heavy though, would need a trailer with probably a winch or come along.
-
Please post pictures or pm them to me
-
I'll try to post pics tomorrow
Coop