Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: zachm on January 13, 2012, 12:41:59 PM

Title: Gcode tool path not cutting properly
Post by: zachm on January 13, 2012, 12:41:59 PM
Can someone look at this GCode and see if they notice anything wrong with it? The pockets were created in CamBam and then produced the GCode. I run the code in a similator and the tool path is correct. I pull it into Mach3 and the tool path looks correct but when it runs. The first two pockets are correct then the next 6 are smaller and then the next pocket the tool runs out of control.

Any help would be great!

Thank you,

Zach
zach@pelicansuperstore.com
Title: Re: Gcode tool path not cutting properly
Post by: zachm on January 13, 2012, 03:09:35 PM
Figured out the solution. It had nothing to do with Gcode but with one of the motors not functioning right. Please ignore this post!!!!!