Machsupport Forum

Support => Downloads => Post Processors => Topic started by: cuesmith on April 20, 2011, 02:11:35 PM

Title: WCAM FastPath, Mach3 Post Processor
Post by: cuesmith on April 20, 2011, 02:11:35 PM

Anyone have a post processor for Waynemark Software WCAM FastPath to Mach 3 ? I've been using this program for 15+ years and hate to have to change. It's a CADCAM program written for the Servo Corp of California that's sold with their machines. Very user friendly but a little past it's prime.

Title: Re: WCAM FastPath, Mach3 Post Processor
Post by: PlasticsProfessor on September 29, 2011, 03:51:35 PM

Contact Greg Brown at 626-395-7613, he wrote the WCam program and should be able to help you.  Good luck.