Machsupport Forum

Tangent Corner => Tangent Corner => Topic started by: fer_mayrl on March 01, 2011, 05:07:15 PM

Title: Anyone here has EDM machine?
Post by: fer_mayrl on March 01, 2011, 05:07:15 PM
hello guys,
Im looking for someone that has an EDM machine that could manufacture a couple of parts for me.

This is a failry simple job, if you have the equipment.
Im attaching a PDF drawing of what is needed.

Just two parts are needed.
Critical stuff, both pieces should mate perfectly so maybe ground surfaces are required. The end of the workpiece where the conical part is, should be ground also.
material is plain steel for now since this is just a prototype, final products would have different outside dimensions and different material.

Anyone looking for some side bucks?
Pls let me know
Best Regards
Fernando