Rebuilding computer

[AMorris]

I had to format my hard drive and start over. Now Mach says my Gallil card does not connect after a reset. I have Galil tools on the computer and that sees the 1842 card ok. I notice my amps are not enabled which I suppose is because the Galil card isn't connected to Mach. Any ideas?

[Chaoticone]

Did you save a copy of your xml file and did you put in the Mach 3 folder after reformatting? Did you also install the Gali Plug-in?

Brett

[AMorris]

I could not save anything from the drive.
Yes, I did install the plugin. If fact, I tried installing it several times along with reinstalling Mach.
Mach does recognize the plugin.

[Chaoticone]

Sounds like you'll have to set up another XML from scratch to me. Did you buy this machine ready to run or build it yourself?

Brett

[AMorris]

Built it myself and it has been running great until my comp crashed. Yes I know, backup, backup and backup.

But I never had this much trouble the first time I installed the pulgin and got everything working. It went as slick as can be. I am using the latest MACH version, the one I had before was older. I doubt that is my problem.

[Chaoticone]

I would think the new would be better but you never know...........

Brett