Plasma kerf width in Lcam

[kevoler]

Can anyone tell me how to set the plasma kerf width in Lcam. If Lcam doesn't have that can it be done in Mach3?

[Overloaded]

In LCam Plasma, you can set up a tool dia. the same as the width of your kerf then offset to the inside or outside...whichever you like.
Never tried it...but it looks like it would work.
RC

[alex718]

I have LC Ver 2.58 and I cannot find where I would enter kerf information. Can you please help me find it ?

Thanks, Alex

[Overloaded]

I jus create a tool, call it what you like, enter the kerf width as tool diameter and offset in or out as normal.
Works in simulation, I dont have a torch table.
RC