Welcome, Guest. Please login or register.
Did you miss your activation email?
May 28, 2012, 01:43:15 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  FAQs
| | |-+  How do I change the z-Axel in Mach3.....
Pages: 1   Go Down
« previous next »
Print
Author Topic: How do I change the z-Axel in Mach3.....  (Read 1586 times)
0 Members and 1 Guest are viewing this topic.
Mikkef
Active Member

Offline Offline

Posts: 3


View Profile
« on: July 01, 2008, 04:20:29 AM »
Hi,
I have Mach3 ver 3.41 and I need to know wher In the setup I can change the Z - axel.
In the G-code it's G-1.0000 and my Z axel go upp and this is wrong...

I whant to change so the Z-axel go down with G-1.0000...  ???and up with G1.0000

Please let me know how I do this... Thank's

Regards
Mikael
Logged
Overloaded
Global Moderator
*
Offline Offline

Posts: 3,073



View Profile
« Reply #1 on: July 01, 2008, 07:23:32 AM »
Top tool bar,
Config
Ports and Pins,
Motor Outputs,
Dir. Low Active.   Put a green check mark in there and try it again.
RC
Logged
"I haven't failed. I've just found 10,000 ways that won't work."         Edison

"You cannot help men permanently by doing for them what they could and should do for themselves."
Abe Lincoln
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!