1st attempt at a Vectric created Lithoplane

[fdos]

Not bad, except I machined through in a couple of places!

VMC was doing nothing much last night so I let it run through the night.   My slow! 6000rpm spindle meant the feedrates had to be kept down with a 1mm dia ballnose.

Subject is Devo's Bob Mothersbaugh wearing my other handiwork on his head!

Wayne....

[Tweakie.CNC]

Brilliant work.

[Chaoticone]

Good Job Wayne. I haven't made any yet because the only mill I have running now is just too slow. My friend was one of the originals working with ArtCam to help perfect the process. Neat isn't it?

Brett

[fdos]

Thanks. well the picture above is of my 1st attempt which screwed up, I machined through in a few places. 

Did it again and was perfect.  I gave the picture to Bob who is the person in the pic last week when I met him in Paris.

I'd try a few more later, but I'll probably build a high speed router to do them on rather than tie up the VMC.

Wayne...