Chucks – LED City set

[chucky]

Let me know if there are any problems or suggestions.
Just hit any bottom button a second time and the MPG will pop out.

[Chaoticone]

Looks great Chucky, nice.

Brett

[chucky]

thx

[zealous]

Nice work looks great..great colors..easy on the eyes..can see from far away..nice 

[chucky]

Updated the file at bottom of post #1

Changed the point to point screen
 Added feed for x,y and separate one for z
 Added drill and peck

Changed some button codes

The drill stuff will not work with the new Version R3.038 for some reason. --Edit works fine with Version R3.039 now

[Fab6657]

 

Hello,

this is super work, thank's

Fabrice

[budman68]

Chuck, you're an artist, my friend and this is a wonderful screen set, thanks so much for your hard work 

[chucky]

Thank you


Here is an update set that gives the point to point screen a whole lot more help, status and info while things are running.

Rename the file to Chucks.set 

EDIT See below for file

[chucky]

This new set will only use x,y feed rate below 0.0000 Z-axis for milling and 100% for moving above 0.0000.

Edit see blow for DL file

[chucky]

This point to point update has 2 basic modes

Auto – when you first open it will.
Turn on the spindle and wait for coolant to prime and use feed rate any time you move and below 0.0000 on the z-axis for all axis.
When you are above 0.0000 z-axis it will use rapid rate for all axis moves.
If you move the z-axis from a +number to a  - number it will go to .120 stop turn on spindle wait for coolant to prime then cut.
Any z-axis move up will use rapid rate.

Manual – hit the manualbutton will.
No matter what move you make they will always move at the rate you set with no spindle stuff.

I also added the ability to set the x and y axis separately for each of the 9 points and more status info.