Welcome, Guest. Please login or register.
Did you miss your activation email?
May 28, 2012, 11:26:26 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Newfangled Solutions Wizards (Moderator: Ron Ginger)
| | |-+  New Wizard "Write/Engraving"
Pages: 1   Go Down
« previous next »
Print
Author Topic: New Wizard "Write/Engraving"  (Read 1943 times)
0 Members and 1 Guest are viewing this topic.
M250cnc
Active Member

Offline Offline

Posts: 591




View Profile
« on: January 25, 2008, 04:13:28 AM »
Hi i would like a write wizard please. I have been using the free one but i want more  control over the positioning of the text. Mainly i want to be able to set the ref point to be in the centre of the text similar to centre justification.

I would buy the New Fangel for this feature alone.  Grin

Thanks
Phil
Logged
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable
Ron Ginger
Active Member

Offline Offline

Posts: 568



View Profile WWW
« Reply #1 on: January 25, 2008, 07:31:25 PM »
Ive thought about a text engraving wizard, but its a lot harder to do than you might think.  It might be more likely if I ever get around to re-writing the wizards in Flash, but so far I have not had much success learning flash.
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!