Mach's Keyway Wizard

[Shepard]

I'm asking Mach's Keyway Wizard to cut .26 width with a 1/8 endmill but only get  1/8 slot. The gcode shows no change in y.  I can't figure out what I'm doing wrong. Could you get me back on track? Thank you,  Shepard 

[vmax549]

Shepard I just ran a simulation and what I saw was that it first cut a center .125 slot down the center, it then did a pocket of the slot width to clean it up and repeated until the depth of cut was reached. Did you actually run the file or just look at the code?

(;-) TP

[Shepard]

I'm an idiot. Thank you. I had not let the file get to the pocket. 

[hornby chopper]

I  cut 2  .250 wide key ways today and  the machine left  a ramp on the opisite side of the ramping of the program but the D.R.O. was going to the right  count every time 

any idea what  is wrong