Jerk parameter selection

I realize this is not supported yet.I am doing a 3D profile mold job with a servo system knee mill and I had to try Quantum. I must say doing a 3D profile with all the small moves, Quantum sure runs smoother. Running this job over 12ipm was choppy with Mach3, could run 30ipm with Quantum. Running acceleration at 15in/sec/sec. I understand the Max Jerk setting, the smaller the number the smoother it runs. My question is how do you figure in the Max Trapezoidal Waveform? Also does the CV setting have any effect on Quantum that should be adjusted? And in tunning should acceleration be adjusted.
Again I must say , this being just Beta version, can't wait till it is in release. This almost puts it on the road to high speed cutting. And Art I hope you don't say that it won't happen. I remember when you said Mach couldn't go over 45Khz. Never say never.
Best regards,
Richard Konnen