Welcome, Guest. Please login or register.
Did you miss your activation email?
May 28, 2012, 12:14:54 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Newfangled Solutions Wizards (Moderator: Ron Ginger)
| | |-+  NFW request
Pages: 1   Go Down
« previous next »
Print
Author Topic: NFW request  (Read 1649 times)
0 Members and 1 Guest are viewing this topic.
vmax549
Guest
« on: August 20, 2007, 07:59:39 PM »
Ron while using the NFW suites it seems that the wizards  assume that the "top of work" Z value is always Zero. This makes it hard to integrate the wizard code into other Gcode programs. Could you change that to have an input for the top of work Zvalue?

Thansk (;-) TP
Logged
Ron Ginger
Active Member

Offline Offline

Posts: 568



View Profile WWW
« Reply #1 on: August 21, 2007, 02:57:01 PM »
If you mean for every wizard in the set, I think I'm to old to start a project like that. :-)

I did look at adding a Ztop to the surfacing wizard, I may be able to add that when I finish the step over problem.
Logged
vmax549
Guest
« Reply #2 on: August 21, 2007, 03:56:48 PM »
Hi Ron , I am not a wizard at programing BUT it seems that it should only be a few lines of code and a entry dro. You are only substituting a variable for a set value. Pretty please Huh

You can't be that old(;-)  I am as old as dirt and I did not see you splashing around in the water when I poped up.

(;-) TP
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!