Mach 3 loading problem

[roadstercycle]

I seem to have to reboot several times before Mach 3 controls correctly. I've tried to just close Mach 3 and turn it on again but it just locks up, so I have to reboot anyway. I am using THC300. Sometimes it loads and controls OK and other times it seems like it loaded correctly but it looses steps, jams the gantry etc. Very fustrating. But when it works it works great.

[Chaoticone]

Sounds like maybe some other programs are running and causing interference. Is this a dedicated PC or does it have all sorts of programs loaded, wireless network connection, etc.?

Brett

[roadstercycle]

Yes it does have, Turbocad, Sheetcam, Mach3, a RF keyboard (problem was there before though) and a network connection for internet. No wireless hub though.

[Chaoticone]

Try turning off everything in your start up file and see if that helps. I have sent you a personal message.

Brett