Welcome, Guest. Please login or register.
Did you miss your activation email?
May 28, 2012, 12:55:35 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Mach3 and G-Rex
| | |-+  GREX and Wierdness
Pages: 1   Go Down
« previous next »
Print
Author Topic: GREX and Wierdness  (Read 1248 times)
0 Members and 1 Guest are viewing this topic.
mhdale
Active Member

Offline Offline

Posts: 130


Knowledge is the Treasure.


View Profile WWW
« on: April 23, 2007, 05:01:03 PM »
Hello all, my system has been acting kinda strange and I am NOT sure where or what the problem is. I have a Grex and It is hooked up to this machine that I am building, this machine is pretty bizarre and basically NOT what Mach was built for but Hey Its motion control right!?  Anyways, I have a Blank screen setup because this control is pretty wierd and I have OEM Buttons to Job My Axis (Specifically A) and they work just fine, but my hotkeys for the a axis dont work, and when I send GCODES like G00 A0.0 The motor will run to the point of startup and then stop, but then it will not respond to any further g codes.... it just ignores them..... any suggestions/pointers?

Mike
Logged
mhdale
Active Member

Offline Offline

Posts: 130


Knowledge is the Treasure.


View Profile WWW
« Reply #1 on: April 23, 2007, 05:26:03 PM »
Ok, I have discovered that it has something to do with the A Axis, because the Z Axis works just fine as far as following G code.... I have turned off the angular motion on the a axis is there something else I need to do to get the A Axis to behave just like x y or z?
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!